How do I install the boundary wire?

The boundary wire is used to tell your MoeBot where it can and cannot go.

The line should be taut and a peg placed every 1 metre
The line can be buried if you wish up to 4cm, but is not necessary
After approx 6 weeks the line will not be visible as it will sink beneath the soil and grass will grow over it
On corners you will need to space pegs approx ever 10cm to create a nice curve

Related Articles
Where do I install my docking station?
Your docking station should be installed on the lawn. Your MoeBot will use the boundary wire from your docking station to: Edge mow Find its docking station
How to identify a break in the boundary wire
Please follow this link for the video instruction: https://youtu.be/w9Buq_dKHVk
What wire do I connect to the positive (red) and negative (black) connection on my docking station?
The wire that runs underneath your docking station via the tube in the centre should be connected to the black (negative) connector and the wire that ends at the rear of your docking station should connect to the red (positive) connector. In correct ...
How does a robot lawn mower work?
To use a robot mower, you first need to set up a boundary wire and docking station. The boundary wire is simple to install, it carries a low voltage signal that tells the robot mower where it can and cannot go. The boundary wire is normally pegged to ...
How to install your water tank on the Ultenic t10
Please follow this link for the video instruction: https://youtu.be/Plx7VPv4wic

Related Articles