The red light indicator is activated

• Related Articles

• What does a yellow, pink, or red light on your PoolBot indicate

  The different indicator colours signal specific statuses of the PoolBot B150. Colour Status Blue Operating normally Yellow Low on charge Red Fault detected / Power Off Red on Charger Charging Green on charger Fully charged Pink No water detected If ...

• What wire do I connect to the positive (red) and negative (black) connection on my docking station?

  The wire that runs underneath your docking station via the tube in the centre should be connected to the black (negative) connector and the wire that ends at the rear of your docking station should connect to the red (positive) connector. In correct ...

• Has debris stuck in the fan

  If the red light indicator turns on and causes the unit to turn off right after submerging your PoolBot B150 it may be due to dust and debris stuck and obstructing the operation of the fan. This may also cause faster battery drain, motor ...

• Has flickering red and green lights while on charge

  Your PoolBot B150 may be malfunctioning due to a clogged power switch. To check for and resolve the issue follow the instructions here.

• Does not climb walls, clean floors, or operate as intended in the pool

  Environmental changes may call for recalibration of the sensors. To recalibrate your PoolBot, first open the cover and remove the filter basket to find out your serial number. Then follow the instructions below to recalibrate the sensors. Before ...