MoeBot: How to identify a break in the boundary wire

• Related Articles

• MoeBot: How do I install the boundary wire?

  The boundary wire is used to tell your MoeBot where it can and cannot go. The line should be taut and a peg placed every 1 metre The line can be buried if you wish up to 4cm, but is not necessary After approx 6 weeks the line will not be visible as ...

• MoeBot: Loop lost or no loop signal

  Loop signal lost means that there is an issue with the connection of your boundary wire, normally a break in the line somewhere. Check to see if you have a blue or red light on your docking station. Blue means you have a good connection, red means ...

• MoeBot: Where do I install my docking station?

  Your docking station should be installed on the lawn. Your MoeBot will use the boundary wire from your docking station to: Edge mow Find its docking station

• MoeBot: What is the maximum length of wire can use on 1 docking station?

  MoeBot S5 | S10 190m MoeBot S20 220m

• MoeBot: How does a robot lawn mower work?

  To use a robot mower, you first need to set up a boundary wire and docking station. The boundary wire is simple to install, it carries a low voltage signal that tells the robot mower where it can and cannot go. The boundary wire is normally pegged to ...