Where do I install my docking station?

• Related Articles

• What wire do I connect to the positive (red) and negative (black) connection on my docking station?

  The wire that runs underneath your docking station via the tube in the centre should be connected to the black (negative) connector and the wire that ends at the rear of your docking station should connect to the red (positive) connector. In correct ...

• What is the maximum length of wire can use on 1 docking station?

  MoeBot S5 | S10 190m MoeBot S20 220m

• How does a robot lawn mower work?

  To use a robot mower, you first need to set up a boundary wire and docking station. The boundary wire is simple to install, it carries a low voltage signal that tells the robot mower where it can and cannot go. The boundary wire is normally pegged to ...

• How do I install the boundary wire?

  The boundary wire is used to tell your MoeBot where it can and cannot go. The line should be taut and a peg placed every 1 metre The line can be buried if you wish up to 4cm, but is not necessary After approx 6 weeks the line will not be visible as ...

• How to install your water tank on the Ultenic t10

  Please follow this link for the video instruction: https://youtu.be/Plx7VPv4wic